Roof plug pic's.

Weekend work bench 2.

Weekend work bench.

Replacement dash & Rear badge mix.

Replacing dash Top looks straight forward.

If I need to save CF, I can use a layer of Fiberglass Cloth.

Can remove quite a lot of the chrome housing. Maybe even open a little of the top, to allow me to 

posistion closer to rear number plate.

Letters for badge replacement, are a little bigger, but will still look ok I hope. I'll still keep most of the "Chrome framing" from the Chrome housing.

Rear light panels 17.

Made the template, by roughly cutting piece of straight plywood. Drilling holes,  on edge to hold filler. Sticky tape, to protect surface. Fast cured filler, so only had to hold for couple of minutes. After removing the inner edge, it'll give me a pretty good line for other side.

Rear light panels 16.

Rear light panels 15.

I'm liking this version better. It ticks all the boxes, for me. 

Still need to finish lines, add to inner light pod, and choose a line, so that I can add divider panel, and lower diffuser, later on. 

 

Rear light panels 14.

Rear light panels 13.

While taking measurements, to continue other side, I figure on trying to raise curve up, infact, cut out entire section, and replace.

I could sweep in as it is, but I'm more in the mind of allowing more ease on any flow, exiting easier.

I've lost the other lower additions for now, making it easy to template things up abit.

Rear light panels 12.

A few lines need smoothing. 

The right "pillar" for licence plate (Terrible bit of sanding:) needs to round off into, centre.

The harsh, horizontal line in centre, needs to go, so the centre section curves, sweeps, in.

All needs going over again, at a later date. But I need to finish up this side for now.

Rear light panels 11.

Rear light panels 10.

Rear light panels 9.

Have to now, make sure theres an effective seal around the rear number plate chrome light housing. Trim as the rear, of the plate holding chrome light housing, bring the line down, from end of wings chrome edging, to newly added pieces.

Rear light panels 8.