Roof plug 9.

Small mistake, revealed in measuring yesterday.
Between either side f the rear section, there was a 3mm difference.
This meant that the petrol cap section , was slightly one sided.
No problem though, cut section out with grinder, re-set today.
Confirmed measurements again today, between front to rear, side to side, levels up and down, and everything is looking as it should be.
The area around the petrol cap is looking good. Slightly raised at either side, blending into surrounding area, makes a nice balance between sheer flat, and curved , sculptured "look".
The side areas are developing, although some thought is needed still, as to "join" to rear downforce wing . Easy to do, but a little more is required to make this area blend in successfully, without making this section look too "awkward".